|
|
|
| 10/26/2003 |
 |
 |
| Shows the stock opening size, and the 3" strips already removed. The cuts were made after marking the QP with a strip sheared to 2-15/16"( strip width minus width of scribe lines). The cuts were made perpendicular to the center body line, otherwise things don't line up when you slide the pieces back to their new locations. The cuts were made just inside the scribe lines with a sawzall, then the tin was shaved with a vixen file to get it "on the line". |
| © 2007 Metalshapers Association |
All rights to the content presented on this site is retained by its original authors or the Metalshapers Association, and appears here under license. Any use by third parties requires permission from the original author. All rights reserved. |
Some of the equipment and methods shown on this site can cause SERIOUS INJURY or DEATH if used improperly or with negligence. The display of equipment or methods here does not constitute endorsement or insure suitability for any particular use. The user is entirely responsible for their own actions, and assumes any and all associated risks. |