|
|
|
Classic Metal
Shop Tour
|
Fabricated wheeling machine.
|
Porsche 550 project car
|
Welding is performed little by little to prevent distortion
The following are pictures from a class Bruce Terry teaches
|
|
Fitting project to buck
|
You can never have enough hands (or clamps)
|
Two parts joined on the buck
|
Here is an example of hammer forming - a small dome will be created here
|
The final project
| © 2007 Metalshapers Association |
All rights to the content presented on this site is retained by its original authors or the Metalshapers Association, and appears here under license. Any use by third parties requires permission from the original author. All rights reserved. |
Some of the equipment and methods shown on this site can cause SERIOUS INJURY or DEATH if used improperly or with negligence. The display of equipment or methods here does not constitute endorsement or insure suitability for any particular use. The user is entirely responsible for their own actions, and assumes any and all associated risks. |
