Terry_Cowan (16K)

 

Ron Fournier

Shop Tour
Courtesy of Tom Lipton

 

mercedes.jpg (36103 bytes)

Mercedes

 

shop.jpg (35432 bytes)

Busy shop

laird1.jpg (20085 bytes)


A year ago I  went to Ron Fourniers seminar in Detroit. 
I took some digital pictures and here they are for the group.
Picture above is a project car that Ron built called a "Laird".
These are pictures of the big buck bucks they used to fab the car.


Tom

laird2.jpg (20133 bytes)

 

laird3.jpg (27976 bytes)

 

laird4.jpg (23610 bytes)

 

air-caulker_and_form.jpg (18480 bytes)

Air powered chasers and a hammer-form




© 2007 Metalshapers Association

All rights to the content presented on this site is retained by its original authors or the Metalshapers Association, and appears here under license. Any use by third parties requires permission from the original author. All rights reserved.

Some of the equipment and methods shown on this site can cause SERIOUS INJURY or DEATH if used improperly or with negligence. The display of equipment or methods here does not constitute endorsement or insure suitability for any particular use. The user is entirely responsible for their own actions, and assumes any and all associated risks.